Skip to main content
Layout, Angles & Rule Tech - SQUAREFORGE precision woodworking tools

SQUAREFORGE Department

Squares, T-Rulers & Calipers

T-rulers, digital angle gauges, center finders and marking tools for repeatable layout and machine setup

30 tools

Heavy-Duty 53cm Stainless Steel Multi-Tool Ruler
Heavy-Duty 53cm Stainless Steel Multi-Tool Ruler

★ 4.9

$27.99
Table Saw Alignment Gauge
Table Saw Alignment Gauge

★ 4.5

$38.99
7-Inch Rafter Square
7-Inch Rafter Square

★ 5.0

$14.99
Aluminum Rafter Square
Aluminum Rafter Square

★ 4.9

$25.99

Know before you buy

Squares, T-Rulers & Calipers

Accurate layout starts with a square you can trust. Our aluminum T-rulers have pencil holes for fast parallel lines, rafter and try squares check 90° and 45°, and calipers read depth and thickness. Engraved scales stay readable after years in the shop.

How do I check a square?

Draw a line along the blade, flip the square and draw again from the same point. If the lines match, it is square.

Imperial or metric?

Many rulers carry both scales. Check the listing photos for the markings.

What warranty and returns do I get?

Every tool ships free in the US with a 12-month warranty and 30-day returns.

Buying guide

How to mark accurately

Accuracy starts at layout. A mark that's off by a pencil width grows into a gap at glue-up.

Engraved scales and pencil guide holes let you draw parallel lines and repeat measurements without a second tool.

Use a knife line

A marking knife or wheel gauge leaves a finer line than a pencil.

Reference one edge

Measure every part from the same reference face.

Check your square

Flip the square and draw two lines; they should overlap.

Common questions

Are the scales imperial or metric?

Many show both; see each listing.

Will the markings wear?

Laser engraving is cut into the surface, not printed.

Is there a warranty?

Every SQUAREFORGE tool has a 12-month warranty and 30-day returns.